IS there a way to have a door automatically add the proper hardware holes for an Aventos-style swing-up door? It would have to be related to the top of the door only... We add these to a lot of different cabinets and it would be much easier if we could just select a different hardware pattern when adding the door.
I'm thinking for the lift mechanisms that mount to the gables as well as the hinges that may/may not be needed across the top of the cabinet.
Aventos - style doors
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
-
- New Member
- Posts: 1
- Joined: Fri, Aug 31 2018, 2:50PM
- Company Name: ACE Concept inc
- Country: CANADA
Re: Aventos - style doors
Hi Mark,
I'm installing Aventos as well.
Did you received any answer so far on this topic ?
Did you find a way to work this out ?
Thank you
I'm installing Aventos as well.
Did you received any answer so far on this topic ?
Did you find a way to work this out ?
Thank you
Michel Pilon
ACE Concept inc.
ACE Concept inc.
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
Re: Aventos - style doors
No, I haven't figured out a way to do it through applied hardware settings or anything.
I ended up making a couple of Part Editor "blocks" that I can bring in and then use Constraint Manager to move them into the correct spot. It's a couple of extra steps, but it works
I ended up making a couple of Part Editor "blocks" that I can bring in and then use Constraint Manager to move them into the correct spot. It's a couple of extra steps, but it works