Profile edge issue

[JR Allen]

Has anyone else experienced a glitch when you select Partial in the profile edge window and select 1 edge okay but when selecting a second edge it selects all 4 edges like a Chain. Seems like I used to be able to profile 3 edges for my tops.

[Carmen Addamo]

I haven't experienced this issue but you could take the piece into contour area, Create edges and then delete the edge(s) you desire. Back to part editor and run the edge profile.

[tim lucas]

Jr

in my test if I click on the bottom next all sides are selected, if I click the top next just the left and top are selected
so it looks like the profile is working correctly. Hope this helps

Tim

[Mark McCallum]

Hi JR
Just testing and yes I experience a similar thing.
In the attached piece it has pockets
I can select the bottom edge
click the left hand edge and it selects 3 more edges or says there was a para solid error creating a new part body.
If I remove part editor parts from entire cabinet in the cabinet editor and try again in the part editor I select the bottom edge can only select either the left hand or right hand side and the selection stops.

Center styles Drill holes only.hsf

(486.02 KiB) Downloaded 401 times