We've been trying to implement the \"Add DXF Part List\" feature on 4.90 that allows us to use an Excel spreadsheet to add part, cabinet and job names to the labels, but we've had no success so far. (We've only tried a couple of tests). I think our problem lies in the File Path field. Is it case sensitive? I see on the help page that rolling_nest uses underscore, yet the control uses Rolling-nest, hyphen. Havent tried underscore yet. Tomorrow. We keep getting a message that says something about no ISAM.
Has anyone else been able to use this feature to get more info on the labels? We are excited about it. Hope we can get it to work.
Dave
DXF Part List
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
-
- Junior Member
- Posts: 98
- Joined: Thu, Jun 30 2005, 10:04PM
It works!!
We were having a problem with the excel spreadsheet/ DXF part list feature. We kept gettig a message \"couldn't find loadable ISAM\" or something close to that. Today, Ryan sent us a DAO file to load onto the controller. Don't know what it does but it fixed the problem. We can now put lot's of info on the lables.
Thanks Ryan and everybody else at Thermwood.
Dave
We were having a problem with the excel spreadsheet/ DXF part list feature. We kept gettig a message \"couldn't find loadable ISAM\" or something close to that. Today, Ryan sent us a DAO file to load onto the controller. Don't know what it does but it fixed the problem. We can now put lot's of info on the lables.
Thanks Ryan and everybody else at Thermwood.
Dave