When we scan a recut part, it loads into the load screen 25.4 times greater than the original cut size. Obviously a metric hiccup.
For example, if I cut a part which is 100mmx100mm and then decide to uise the recut barcode and scan in the part, the part ends up becoming 2540mm x 2540mm.
Could we please have this looked at for the next update.
Regards
Barry
CN 5.58 bug with Metric re-cuts
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 8
- Joined: Thu, Mar 04 2010, 5:59PM
- Company Name: Abes Benchtops
Re: CN 5.58 bug with Metric re-cuts
Hi Barry,
Thanks for the information. We will have a look into this issue.
Thanks for the information. We will have a look into this issue.