Need program for parts which are beyond my experience and software capabilities.
These four parts have strict deadline so I am hoping I could hire one of you to write the cnc program for my CS 43.
The problem is carving the area where two cove molding shapes make an inside corner.
I have attached a picture of the type of look I want. Also is attached a 2d dxf drawing.
Need four parts double sided, (2) 5 x 56 and (2) 5 X 66.
If you can help me out with this please call with cost, and time. 973-224-0221
Discuss Thermwood 3-axis Machinery, Controller, and Software.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests