Corner Cabinet Back

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Nicolas Barbeito
New Member
Posts: 23
Joined: Thu, Jan 26 2012, 9:36AM
Company Name: Zimmerman Furniture Co
Country: UNITED STATES

Corner Cabinet Back

Postby Nicolas Barbeito » Fri, Apr 13 2012, 9:54AM

Is there a way to make the miters miters on the backs of the corner cabinet a 45 degree instead of a 22 1/2? My guys don't like the 22 and are insisting I make the back a full overlay with a 45 on the side backs.

Thanks for any help.

Scott Marshburn
Guru Member
Posts: 736
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Corner Cabinet Back

Postby Scott Marshburn » Sat, Apr 14 2012, 5:16AM

Are you cutting out your parts by hand if so you could change the corner gap to 0 and check miter 90 deg. Corner. This would give you plenty to cut the 45s you are after.
I cant see any way to make the miters change and cant seem to extend the left and right backs in the correct direction to allow enough to make them 45s
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Bing [Bot] and 4 guests