Offfall nesting corner not obeying

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Jeremy Schiffer
eCabinets Beta Tester
Posts: 944
Joined: Tue, May 10 2005, 9:36PM
Location: Carnesville, GA
Contact:

Offfall nesting corner not obeying

Postby Jeremy Schiffer » Mon, Apr 28 2014, 10:36AM

Using CN 5.78, the nesting position for offfalls (lower left, upper right, etc.) is not obeying the setting. It is always nests in the upper right. I don't see anyone else complaining about this, so I wonder if it is somehow specific to my machine. I just updated to 5.78, so I'm guessing it is something to do with that. Is there a settings file I could delete that will get it cleared up perhaps? Anyone had the same problem?
http://www.corlanecabinetry.com

Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit

User avatar
Jeremy Schiffer
eCabinets Beta Tester
Posts: 944
Joined: Tue, May 10 2005, 9:36PM
Location: Carnesville, GA
Contact:

Re: Offfall nesting corner not obeying

Postby Jeremy Schiffer » Mon, Apr 28 2014, 11:00AM

Solved... I had to check "ignore settings grouping"... now all I gotta do is figure out what that is and how to use it. :joker:
http://www.corlanecabinetry.com

Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 5 guests