annoying CN bugs
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
Tommy Wieler
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
annoying CN bugs
FYI, we still occasionally get completely random offal generation when we manually move parts around in the nest. Also, sheet diagrams go completely bonkers when we manually move parts that contain profiling. would be GREAT to get these resolved
-
Mark McCallum
- Guru Member
- Posts: 516
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: annoying CN bugs
Hi Tommy.
I'm not sure if this is related to to this post from a while ago. But you might see if its the rectangular nesting causing the bugs.
https://www.thermwood.com/forums/viewtopic.php?t=18398
I'm not sure if this is related to to this post from a while ago. But you might see if its the rectangular nesting causing the bugs.
https://www.thermwood.com/forums/viewtopic.php?t=18398
-
Brad McIntosh
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: annoying CN bugs
Tommy,
If they have not done so already, someone from our Software Group here at CNC Automation will contact you shortly to look into your issue.
If they have not done so already, someone from our Software Group here at CNC Automation will contact you shortly to look into your issue.