Has anyone looked into using AFL to write a subroutine that will rise out in a beveled corner? We do a fair amount of this type of work and need a solution for cutting the fronts from Ecabs.
Forrest
Writing code with AFL
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1237
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1237
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Writing code with AFL
I take that as a no, lol.
Since this "engrave" feature is available in almost every cabinet design software with the mdf module that I've encountered so far and the "cut center" from Thermwood, I would assume it will be added to control nesting for us regular guys at some point. I wouldn't think it's that hard of a process to code for guys who are good at it. I was hoping it could be done with a macro. Unfortunately time is limited these days and I haven't been able to sit and wrap my head around it yet.
Maybe Thermwood will chime in,
Forrest
Since this "engrave" feature is available in almost every cabinet design software with the mdf module that I've encountered so far and the "cut center" from Thermwood, I would assume it will be added to control nesting for us regular guys at some point. I wouldn't think it's that hard of a process to code for guys who are good at it. I was hoping it could be done with a macro. Unfortunately time is limited these days and I haven't been able to sit and wrap my head around it yet.
Maybe Thermwood will chime in,
Forrest