Thermwood.com - eCabinet systems update.

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
David Hall
eCabinets Beta Tester
Posts: 593
Joined: Tue, May 17 2005, 12:41PM
Location: Stamford, CT USA
Contact:

Thermwood.com - eCabinet systems update.

Post by David Hall »

The \"eCabinet systems update\" link on thermwood.com could use an update.
--------------------------------------------------------------------------------

eCabinet Systems Update
--------------------------------------------------------------------------------



5/17/06 - The latest update is eCabinet Systems 4.1 Build 4
(this is an update to eCabinet Systems - you must still install the program from the disk that was mailed to you)
David Hall
Hall's Edge Inc.
eCabinets Machining Services
http://www.HallsEdge.com
Jason Susnjara
Thermwood Team
Posts: 1721
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Post by Jason Susnjara »

Hi David,

Thanks, will get it fixed
Post Reply