nesting and cutting edited display panels

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Roger Erismann
Senior Member
Posts: 169
Joined: Sun, Dec 04 2005, 11:42PM
Location: Sacramento, CA and Rolla, Mo

nesting and cutting edited display panels

Postby Roger Erismann » Tue, Jan 23 2007, 7:20PM

I work at a place that uses e-cabs now(no I work on the floor) however they asked me to look at a display panel they were trying to cut...

Basically a panel with a 1/4x 3/8 dadoe off one long side...well when I used the part editor everything went well however when we went to nest it no dadoe was present....I believe they solved it (by callinbg Thermwood) however I was curious as to why it does not nest correctly?

Roger
Wood Butcher/Case Maker

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests