Batch Cabinet & Nesting question

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Bryan Wilson
Junior Member
Posts: 38
Joined: Thu, Dec 29 2005, 10:37AM
Location: Elkhart, TX

Batch Cabinet & Nesting question

Postby Bryan Wilson » Thu, Feb 15 2007, 4:27PM

Thought I would try to use batch cabinets instead of cutom layout like I usually do.
Everything seemed OK but then I noticed when I went to the sheet Layout (nesting) that in filters and on the layout I only had one of each cabinet even though I had 2 cabinets (assemblies) with a quantity of 2.
Is this normal because I can always change the name of 1 assy and add a second under diff. names.
I checked the cutting list with the quanity @ 2 and it showed right then went to nesting and only got one assy.
Just seems a little odd.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 12 guests