5 piece doors

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Lee Gernandt
Junior Member
Posts: 57
Joined: Wed, Nov 01 2006, 6:33PM
Location: Faribault MN
Contact:

5 piece doors

Postby Lee Gernandt » Tue, Feb 12 2008, 12:51PM

When I input the info for build doors in house, I input 1/8 for machining allowance. On my cutlist, Some of the stiles only have the 1/8" added to them, which is what I want. Other stiles and all the rails have 1/4" added to them. So far all the problems I've encountered have been my own fault, so I don't expect this to be any different. But if someone could give me a clue to correct it, it would sure be nice.

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 7 guests