Purchased doors

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Gary Urlacher
Junior Member
Posts: 76
Joined: Mon, Jun 02 2008, 11:39AM

Purchased doors

Postby Gary Urlacher » Wed, Jun 04 2008, 10:57PM

Hello everyone, I am new to ecabinets but I am finding that it works very well
and the interface the the router is magic.

I out source my doors and I am looking for a way to have a report that will act as a
door order list. The only place I can find door information is on the cut list.
I can't find a way to export that information and or creat my own report.

Can some one point out how this can be done?

I am also unable to get hinge holes to work on a 45deg angle upper corner cabinet.
I assigned a 45deg hinge with a hole pattern and it shows up on the door but not the
cabinet gable itself.

Thanks in advance for any help

Gary Urlacher
Spruce Grove, Alberta

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 12 guests