Discuss Thermwood 3-axis Machinery, Controller, and Software.
2 posts • Page 1 of 1
Another thing that may be useful for users of Rolling nest is to be able to tell the system to make more than one pass depending on the thickness of the material being cut, viz if I were cutting 30mm MDF I could set up to make 2 passes or 3, whatever the material dictated.
- Bill Rutherford
- eCabinets Beta Tester
- Posts: 386
- Joined: Tue, May 10 2005, 5:23AM
- Location: Lancaster, NH
Who is online
Users browsing this forum: No registered users and 8 guests