How do you

Gary Puckett · Post by **Gary Puckett** » Sun, Nov 30 2008, 9:31PM

How do you find where the contour is not closed? I have extended every line there is and then trimed them and it still says the contour is not closed

Gary

Damon Nabors · Post by **Damon Nabors** » Sun, Nov 30 2008, 9:55PM

Gary,

Sometimes the lines will overlap each other and you will not see the problem. Another problem is splines, they cause problems also.

Rick Palechuk · Post by **Rick Palechuk** » Sun, Nov 30 2008, 9:58PM

There's a ton of stuff on this topic in search Gary. http://www.thermwood.com/forums/viewtop ... sed#p37435

Grady Pinckard · Post by **Grady Pinckard** » Mon, Dec 01 2008, 7:17AM

Gary,
Sometimes you will have to shut down e-cab and restart. I know you have to do the drawing again but its the only way.
Grady

Kerry Fullington · Post by **Kerry Fullington** » Mon, Dec 01 2008, 7:26AM

Gary,

Make sure you have Object Snap turned on and Grid Snap turned off when you are extending and trimming your lines.

There are also times when you may have two lines, one right on top of the other and this is the problem.

Save the geometry you are working on and post it. Maybe I can help.

Kerry

Gary Puckett · Post by **Gary Puckett** » Mon, Dec 01 2008, 8:01AM

Thanks Guys I finally got it. For some reason I clicked in a different spot and it did it
Gary

Thermwood / eCabinet Systems

How do you

How do you

Re: How do you

Re: How do you

Re: How do you

Re: How do you

Re: How do you