Thermwood / eCabinet Systems

Jason,

If I remember correctly when this happen to us it was a lose connection on the encoder cable.
Shut down the machine and check the encoder cable at the Z axis motor and on the servo drive in the control cabinet.
Take them off and put them back on (this helps clean the pins to make a better ...

There should be no limit as long as you keep it maintained. Grease/oil when required and keep the filters on the A/C unit clean.
We have run ours 24/7 without any problems. We routinely run 12-13 hour long programs, unload and load new material and start it again without any major problems.
Clean ...