Thermwood / eCabinet Systems

Clint,

Thank you for the response. I performed the steps you described and the program did load cabinet pics however the response to commands were extremely slow. The pics would hardly move and are too slow to use. I will look into having a new graphics card installed. Have a great day.

Marvin

I uninstalled ecabinets and reinstalled. Restarted the computer. Did this evolution two separate times. Still have the problem. I checked the graphics card and got a message that it was working okay and that I had the current version of the driver.

When I click on develop cabinets or assemblies and then click on an existing cabinet, no cabinet picture comes up. The information box does list the cabinet specs. Also when doing batch cabs no picture of nested parts comes up. I had a virus on the computer which was supposed to be fixed by the Geek ...

Rick,
I updated the driver and IT WORKED....eCabinets folks are the smartest....I wish one of the guys or ladies would run for president..
My sincere thanks.
Marvin

I just upgraded two Windows 7 laptops to Windows 10 and eCabinets will not run unless I right click on the eCabinets icon and click on “run with graphics processor” and then click on “integrated graphics (default). If I click on “High performance NVIDIA processor” eCabinets gives a “program has ...

Tim,
Got it....thanks a bunch.
Marvin

Tim,
Thanks for the reply. I opened the libaries and got a list of cabinets and furniture. I did not see a pulls section. Did I go to the right area?
Again, Thank You.
Marvin

When I go to the pulls library there are not any pulls to chose. Is shows all manufacturers 0 products and all distributors 0 products. Where or how do I get a download of pulls in include. Thank you

I have updated eCabinets and I am using version 6.0 Build 5. I open eCabinets this morning and got a note that said the application was expiring in 9 days. What do I need to do so the application does not expire.
Thanks

Kerry, I perform the steps you address and that works fine for about two to four leaders. Subsequently I have problems getting the leader to work. I will move the leader symbol to where I want a leader and click and the leader symbol turns to a short vertical line (looks similar to a capital I with ...

I am having difficulty using the leader in the line drawing editor. Sometimes it will work and sometimes it will not work. Is anybody else having this problem? I am open to any advise and suggestions. Thank you.

In the line drawing editor, when dimensioning in 3D, free form, the dimension line will cross through the dimension number making it hard to read. When dimensioning in 2D This does not happen. Any suggestions. Thank you.

Brad, Thank you for the information. The computer I am using is a Dell and I did use the disk that came with the computer to re-install the drivers. I did an update to the graphic controller software and eCabinets works just great. I hope you have a super day.
Marvin Pate

I just reformatted my hard drive and have reloaded Windows XP, internet explorer, Microsoft Office and eCabinets. All programs work fine except for the cabinet editor in eCabinets. I loaded eCabinets 5 from the disk and did an internet update to the current version. I also did a defrag to my hard ...

Rick, Thanks for the reply. Of the many things I like about eCabinets is the forum and the quick responses I get from very knowledgeable people. Have a great day.....