Thermwood / eCabinet Systems

right. I do use 4 screws per slide but drill 10 holes I think.
Thanks

Is there anything I can do to improve the efficiency of my drilling especially on my blum tandems? It drills some of the holes on all the parts and then has to come back and do the rest. I waste a lot of time jogging around the table. This is on my shopbot with the link.
Thank you
Lorin

http://www.microsoft.com/downloads/deta ... laylang=en

Thermwood had me download this and it works now.
Lorin

Ecabs has been closed. I guess there is some problem with my computer as my old one would work with version 5 on it.
Lorin

Windows XP

I tried the frameless libraries. base, upper and corner/special cabinet ones.

OK so now I connected to the web and upgraded to version 4. I still get the same problem. Is there a fix for this? Am I missing something on my computer?
Lorin

Did you figure out the cause of the problem? I too am running into this. The computer I have Ecabs on is not yet connected to the net so I save them to a thumb drive but they don't install and I get the same message.
Lorin

I don't even know the specifics of my ststem. I had it put together by a friend using surplus workstation. I am very impressed by the speed of 6.4. Everything seems to finish up in seconds as compared to minutes with 5xx and old computer.
Lorin

stuck them all on thumb drive and moved them. Didn't bother with the images. I just like them for the buy list and the hole patterns. Sure having trouble getting the hinges to add to the cabinets but it appears after searching the forum I am not the only one.
Lorin

When I upgraded to v6.3 I did so on a new computer. Do I have to move all the hinges and slides as well as the hole patterns or should they be in the system as they are in my old computer running V5? All I get is an empty list when I go to add hardware.
Thanks
Lorin

Don't get me wrong. I think ecabs and the shopbot link are the best things that have happened for my business. I have no doubt it can do it just that I need to get more familiar with the part editor.
Lorin

I am still quite weak with computers. I am not even sure how to post the pic. I think for this job (which I am doing with no rendering- thankfully) I will tool path seperately with Aspire. I haven't figured out the part editor yet as much as I have studied my Ecabs guide. I supppose when I get time ...

I am trying to design an isalnd to replace an existing one. The center cabinet is a 22 inch bank of drawers(easy). On each side is a quadrilateral?? (unsure on terminology) with a single door. The front side with door is 14 5/8" wide. One side is 90 degrees to this and is 24 inches. The other side ...

I got it open now, thanks for the email help Kenneth and all the help from the rest of you. Now I just have one small question. What would I do to change my height. When I try make it 40" tall it comes up with change would result in unstable back? Am I missing something simple?
Sorry for all the ...