Thermwood / eCabinet Systems

Thanks Daniel. The signal seems to come and go, probably due to the building and distance from the router. I have already considered a hard wire to the router, then trying to connect the PC to the cnc. Might be my only option.

For the last month, off and on, I have been trying to get our Windows 7 PC to wirelessly connect to our cnc, also with Windows 7. Hoping to do this to transfer files from the PC to the router, instead of using the USB drive back and forth between the two. I also want the CNC to be online if remote ...

Thanks for all the replies. My thought with using the .096 was that, being much thinner than the .17, I wouldn't be getting a deep enough cut through the sheets we are cutting, and I would have to adjust all of my parts files to allow for the deeper cut I would need. Using 2 of the .096 sheets ...

That worked, thanks.

This is from someone pretty new to CNC work, so hopefully my question isn't too idiotic.

I noticed the flycut procedure only lets you go down to about .17 inches, then won't let you flycut anymore. To set up a new wasteboard, you then obviously need a board at least .17 inches.

We have a very ...

Hi, new here and working with a new Thermwood router over the last week.

A few days ago I tried to set up a wireless adapter to the control unit so that I could remotely send files from my office PC to the router, and to allow technical help if needed.

When running the setup CD, a prompt came up ...