Thermwood / eCabinet Systems

So, if I want a room that is a polygon with all 90 degree angles I should have the numbers ready to go before I enter custom layout. Do the math elsewhere.

I can't find the fillet command for walls in Custom Layout. You know, two walls as 90 degrees that don't quite meet. You want to extend or trim each so they make a 90.

Simon Randall wrote:is it a plan shaker door you are looking for with like 6mm ply centre panel (flat both side's) and H/wood frame?

Yes, just a plain door.

I have a solution of sorts.

First, create an edgebanding that is the width of your stile minus the depth you want the panel to go into the grove. For instance, say you have a 3" stile with a 1/2" groove for the panel and you want the panel to go 7/16" into the groove. Make the thickness of your ...

That's what I do. I use a bottom so that I get a good representation in the plan of the job window. Maybe someday.

For what it's worth, I haven't found this in any other cabinet package either, at any price. They give a drawing and a cut list which is fine as far as it goes. But if you 45 doors and ...

Does eCabinet support plywood for door panels. If so what about a nesting diagram for the panels?

It does it for drawer bottoms so I was just wondering. Thought I'd ask before giving up.