Thermwood / eCabinet Systems

thanks for the help. Like Pete at Thermwood said to me ,problems are usually user error. It wasn't a G60L1 code it was a M60L1 code. I had settings wrong in the settings page of control nesting. Everything is good.

Hi,
Your right the G60l1 checks input
Switch 1 ( my pop up pins) is on. Thing is
At this point they are off. Machine locks up.
I block stop, press TAB, change to G60l-1 (check
Input 1 is off which they are) press enter
Then cycle start. There is no M00 in the code
This is right at the beginning ...

Hi everyone,

I just got my cs 43 running. When I use controle nesting to generate cnc code and then run it, the sequence stops on a G60L1 code and will not move to the next command unless I either delete the line or change it to G60L-1. then cycle start to continue. Does anybody know why?

Thanks ...