Thermwood / eCabinet Systems

What are some options for designing corner cabinets. Ecabs is just so restrictive when it comes to corners. No partitions, no stretchers. two quick examples are a base corner cab that I want to install deck sleepers. or an upper with no rear corner gap on the exterior design but I dont want a inside...

I notice the software avoids assemblies altogether. Have to manually place a note in custom layout.

Stuart would it work to just use a top inset and then lock the drawer box height to (X)

Anyone know if it's possible to change the numbering of cabinets in a room. Ecabs numbers the cabinets as they are placed in a room but sometimes a room is designed in an odd sequence or a cabinet is removed and replaced with another after the initial design. You often end up with wall (A) having ba...

Scott, Thanks for the advice. Problem solved.

I'll post jpeg's of the cabinet and tool. I want to profile the piece on the right side of what would be a fireplace opening. The left side and top have been profiled.

I know I have done this before but cant seem to figure it out today. I have two stretchers, one left, one right. I cut a profile on the inside edge of the left stretcher. Now i need to cut same profile on the inside edge of the right stretcher but the tool profile i created in ecabs is not symetrica...

Forrest has a good solution. When I have the situation you describe I always just make the reveal settings so the reveal total is first calculated and then divide equally (divide by 3 in your double door case). This is so both doors are the same width and only their location on the cabinet is slight...

Kerry that would be great. Thank you for offering.

Scott Thank you for the suggestions. Your ideas definitely helped me elevate my designs.

Turning an attic into bedroom with large number of built-ins, custom bed etc. How would you handle the floor opening/stairs. I can only think to create a railing/knee wall around the location of the openings. Use a display cube to simulate an opening in the floor??

Travis in construction settings in the right/left sides tabs. under "Construction" > Front. Choose the appropriate construction method. Full dado, blind dado etc. Then set your dado depth in construction parameters in those same tabs.

In it's simplest form I have a display cube. I want to apply part editor cuts to the face and also to the top. Is there any way to do so. The project is a vanity with two towers. Between the towers sits an arched bridge (soffit). The bottom of the soffit will have a frame and panel effect. To create...

Rick, Sorry about the delay in posting this. If you take this cabinet and try and install a partition, and mid stile, you will first notice the mid stile does not connect to the bottom rail. I have a negative float for the deck to act as a door stop. Then try to install a door and you will see it do...

Rick, I'm sorry but I would need some instruction on how to post a file.