Mac users and loosing holes

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Mac users and loosing holes

Post by Mark McCallum »

Does anyone else loose their hole patterns when they save them as an assembley on a mac.
I don't know anything about Macs but another user does her ecabs work running in a sand box situation on a mac.
When she saves anything as an assembly, when we touch anything, change height, width or depth the applied hole patterns disappear.
Clint and the guys have been amazingly helpful and we finally tracked it down to the mac thing.
eCabs is designed to run on windows but I was wondering has anyone else had the same thing happen or if its specific to her machine.
All the drivers are supposedly up to date.
I have attached a assembly to demonstrate.
Untouchable.jpg
Untouchable.jpg (9.2 KiB) Viewed 4790 times
Untouchable.esa
(1.55 MiB) Downloaded 377 times
Just resize anything and Pooofff, hole patterns should disappear.
Any help appreciated.
Thanks
Mark
Post Reply