Problem with edge banding

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Ian Richardson
Junior Member
Posts: 76
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

Problem with edge banding

Post by Ian Richardson »

Hi everyone, this is a first for me. I have attached a pic.
I have a batch of cabinets, when I click on nest diagrams I get this message pop up multiple times. I just keep clicking OK!
I tried searching the forum...nothing
Any ideas?
Attachments
Capture.PNG
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Problem with edge banding

Post by Clint Buechlein »

Ian,

Can you post the cabinet (or job of cabinets), and if they were made from seed cabinets, those cabinets? If it is too large to post, you can upload here https://info.thermwood.com/thermwood-file-upload-page, just make sure to reference this thread.

There is a mismatch between parts and edge banding data that some customers have discovered. Its becoming difficult to pinpoint, so this is a new error message added to 6.2.9 to help detect it.

-Clint-
Ian Richardson
Junior Member
Posts: 76
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

Re: Problem with edge banding

Post by Ian Richardson »

Thanks Clint, next time it pops up I will upload
Post Reply