Cabinet Label Question

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Jon Forsgren
Junior Member
Posts: 72
Joined: Wed, May 18 2005, 9:12AM
Location: Camano Island, WA

Cabinet Label Question

Post by Jon Forsgren »

I created an assembly saved to a directory. No prob. I then wanted to save it to another directory. Saved both the cabinets and assembly to new directory. When I returned to room (applied changes), it still shows the cabinet (assembly) under the old name. If I choose the assembly and return to cabinet editor, the new name and location are in the box on the left, but the bar at the top still shows the old location and name. I have made new directories both as sub-directories and higher level directories. Where did I boo-boo?
Attachments
Wrong directory
Wrong directory
Right directory
Right directory
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Cabinet Label Question

Post by Donald Thomson »

Just because you saved it under a different directory doesn't change the cabinet that is in your layout. You will need to delete the original one and then load the second one you saved back into it's place in the room. This process makes the second saved cabinet the one in the room.
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Post Reply