Error in Part Editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Error in Part Editor

Post by Kerry Fullington »

I am performing some cuts to the front of a drawer box in the part editor using a saved pattern.
Everything works fine until I return to the Cabinet Editor, and I get this error.
Clipboard01.jpg
This part is fine as long as I don't add constraints and try to re-size the box in the Cabinet Editor.
If I resize, I get the error to remove part editor cuts, or remove the drawer box.
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Error in Part Editor

Post by Donald Thomson »

Aren't those error messages informative. :lol:

I've had these types of errors, on many occasions, and ended up just deleting the part and starting over. It wasn't worth my time to investigate why it was happening. Just one of those weird software gremlins....
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Post Reply