I am performing some cuts to the front of a drawer box in the part editor using a saved pattern.
Everything works fine until I return to the Cabinet Editor, and I get this error.
This part is fine as long as I don't add constraints and try to re-size the box in the Cabinet Editor.
If I resize, I get the error to remove part editor cuts, or remove the drawer box.
Error in Part Editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Re: Error in Part Editor
Aren't those error messages informative.
I've had these types of errors, on many occasions, and ended up just deleting the part and starting over. It wasn't worth my time to investigate why it was happening. Just one of those weird software gremlins....
I've had these types of errors, on many occasions, and ended up just deleting the part and starting over. It wasn't worth my time to investigate why it was happening. Just one of those weird software gremlins....
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com