Hardware hole patterns

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Forrest Chapman
eCabinets Beta Tester
Posts: 1230
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Hardware hole patterns

Post by Forrest Chapman »

It would be great if the hardware hole editor allowed patterns created below the x-axis to reference from the top of the front. This would allow us to use a pattern for flipper hinges easily.

It would also be nice if a door allowed for a top hinge too.

While I'm on the subject what about a pattern that will apply to the back of a blind corner panel?

Thanks, Forrest
Post Reply