Constraints with lock Dado error

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Constraints with lock Dado error

Post by Mark McCallum »

Can anyone else reproduce this?
Standard base frame less.
Control C
Apply lock dado construction via global settings.
Change KDA RTA's
Take bottom shelf into part editor.
Put a rectangular geometry onto the back edge overlapping the back edge.
Pointer, Right click, Cut pocket using closed contour.
Cut through.
Return to main, keep changes.
Take bottom shelf into constraints manager.
Apply the 3 constraints as in the picture.
Dado causing error 1.jpg
keep changes and this error message comes up, revert to previous cabinet, when you exit and the sizes are kept and the geometery changes.
resizing the cabinet makes it more unstable.
I think its something to do with the cutout overlapping the dados?
I also played around with the top shelf.
It seems to behave slightly differently.
Once you go past the self intersecting constraints sizes (the cabinet size where the constraints limit the cabinet size), you get error messages and it becomes corrupted.
Dado causing error.jpg
Dado causing error 2.jpg
thanking you
Mark
Attachments
Std Base Frameless error.hsf
(838.02 KiB) Downloaded 96 times
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Constraints with lock Dado error

Post by Mark McCallum »

Just another example
Change the cabinet width from 782mm to 630mm.
Works okay
Attempt to change it back to 800mm error message wants to revert to previous cabinet.
Attachments
Std Base Frameless.hsf
(790.02 KiB) Downloaded 98 times
Post Reply