Tenon issue

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Ian Richardson
Junior Member
Posts: 76
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

Tenon issue

Post by Ian Richardson »

Can anyone shed some light on this issue. 3/8" cuts the tenon. 1/2" cuts the outline.
You can see in the picture that the 2 cuts are not lining up. I have checked the diameters of the 2 tools.
I have seen this before but cant remember what the fix was
Can anyone help
Thanks
Ian
Attachments
tenon
tenon
Jeremy Schiffer
eCabinets Beta Tester
Posts: 1119
Joined: Tue, May 10 2005, 9:36PM
Company Name: Corlane Custom Cabinetry LLC
Country: UNITED STATES
Location: Carnesville, GA
Contact:

Re: Tenon issue

Post by Jeremy Schiffer »

We definitely had an issue that caused the same result, and it turned out that the bolts holding the Z-axis guide rails to the mounting plate had come loose, and the head was wandering because of it. Check all of your fasteners, including the ones holding the motor to its mounting plate.
http://www.corlanecabinetry.com

Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit
CS-41 4x8
CS-45 5x12
Post Reply