Ramp-in location

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Tommy Wieler
Senior Member
Posts: 124
Joined: Fri, Sep 22 2017, 7:49AM
Company Name: Silverpine Cabinets
Country: CANADA

Ramp-in location

Postby Tommy Wieler » Fri, Aug 20 2021, 2:47PM

I noticed that when using Conventional with Outline Non-Final Pass Climb, the ramp in location is set so that the END of the ramp is located at the corner of the part. When using the single-pass outline cuts, the BEGINNING of the ramp is set at the corner of the part. I would love to be able to combine those two configurations: use a single-pass outline cut and specify the ramp-in to end on a part corner. Is there any way this can be done, and if not, would Thermwood be willing to consider making this an option in a future update?

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 6 guests