Not nesting properly

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Matt Snowball
Junior Member
Posts: 30
Joined: Wed, Jun 04 2008, 5:00AM

Not nesting properly

Post by Matt Snowball »

Hi all,

Just encountered a weird issue on my CS41 . Everything has been fine for years, now:

Each part is being nested on its own separate sheet (and the sheet looks to be the same size as the part itself)

Some parts are also extending beyond the bed when nested.

Any ideas ?

Thanks

Matt
Attachments
2B4DA5A0-8CBE-4F5B-A6A9-C8287CF34BF3.JPG
Matt Snowball
Junior Member
Posts: 30
Joined: Wed, Jun 04 2008, 5:00AM

Re: Not nesting properly

Post by Matt Snowball »

OK panic over,

for some reason I had the 'Scrap Part Recovery' checkbox ticked in the load screen . Phew.
Post Reply