Anybody can tell me where I can find this drawing or something very similar ? I have to machine it on my CNC and I'd like to save the drawing....Thanks
total width = 30\"
total height = 9\"
Looking for a drawing
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
DanFecteau
- eCabinets Beta Tester
- Posts: 278
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Looking for a drawing
- Attachments
-
- DSCF0014.JPG (357.52 KiB) Viewed 2910 times
-
- DSCF0015.JPG (352.53 KiB) Viewed 2910 times
-
Michael S Murray
- eCabinets Beta Tester
- Posts: 933
- Joined: Tue, May 17 2005, 2:48PM
- Location: Logansport, In
- Contact:
Hey Dan, I seen this earlier but did not reply because I could not help directly.
I know that when I was in Art-cam training at Thermwood there were some books in the office that had thousands of carving's in it. Some one had compiled these drawings and written code for them I beleive. Contact Lee Brumley @ thermwood and I am sure he can lead you to it on the internet or maybe directly.
lee.brumley@thermwood.com
hope this helps, I know that is a fairly commom design.
Mike
I know that when I was in Art-cam training at Thermwood there were some books in the office that had thousands of carving's in it. Some one had compiled these drawings and written code for them I beleive. Contact Lee Brumley @ thermwood and I am sure he can lead you to it on the internet or maybe directly.
lee.brumley@thermwood.com
hope this helps, I know that is a fairly commom design.
Mike
