Corner Cabinet Crasher (Attention Thermwood Guys)

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Joe Dusel
eCabinets Beta Tester
Posts: 1117
Joined: Tue, May 17 2005, 9:40PM
Location: Vista, CA, U.S.A.
Contact:
Contact Joe Dusel

Corner Cabinet Crasher (Attention Thermwood Guys)

Post by Joe Dusel »

The attached cabinet is something I was mucking with to see if I could coax a corner cabinet into becoming an extended end cabinet. Apparently it didn't work, but the software still should not crash as soon as the Door Editor is opened.

By the way, I reduced the Right Front to 0\" using the associated up/down tabs. Putting in the number 0\" gives me the warning message that the software is not going to like that number.

Joe
Attachments
RH blind Corner 2.hsf
(143.56 KiB) Downloaded 602 times
RH blind Corner 2.jpg
RH blind Corner 2.jpg (11.1 KiB) Viewed 4092 times
Top
Walker T Scott

Post by Walker T Scott »

This was a slight over sight with the spin buttons which will be fixed. The right or left front can not be less or the same as the material thickness. If you are using a ¾ material you can type in .755 and it will accept it.
Top
Post Reply

Return to “eCabinet Systems Software”