Building Stairs

Bill OConnell · Post by **Bill OConnell** » Tue, Aug 30 2005, 3:16PM

Does anyone know of any programs to allow the cutting of stair parts on a CNC machine?

Thanks.

Jeff Norris · Post by **Jeff Norris** » Tue, Aug 30 2005, 4:56PM

mastercam has a macro for cutting stair stringers, it will also cut both stringers for an open riser stair case, miter the returns and everything.

Forrest Chapman · Post by **Forrest Chapman** » Tue, Aug 30 2005, 5:03PM

Hey Bill again,

There are cadspecific stair programs out. However out of respect for this forum I'd rather not say who it is. Do a simple search and it should popup.

Forrest

Jeff Norris · Post by **Jeff Norris** » Tue, Aug 30 2005, 5:33PM

thermwood sells mastercam