Add doors to Library

Russell Walker · Post by **Russell Walker** » Thu, Mar 15 2007, 2:07AM

Hi All

Our we able to play around with doors etc. in the part editor and save then in the relevant library for future use? I have just completed a kitchen with 23 doors along with 8 drawers, and had to do each front seperately. I was hoping to do one that saved as a default for the others.

Cheers Russell

Michael Yeargain · Post by **Michael Yeargain** » Thu, Mar 15 2007, 5:23AM

Yes Russell,

You can modify any of the doors and save them into another directory to be used at a later time. Once you get the door the way you want. Click on the save button and give it a name and directory.

Mike Seisser · Post by **Mike Seisser** » Thu, Mar 15 2007, 7:25AM

Russell,

At this time doors aren't supported in the Part Editor. Also, I'm pretty sure that you can't batch these doors either. Do you have a need to add doors/drawerfronts to a batch and be able to resize them on the fly?

Mike

Michael Yeargain · Post by **Michael Yeargain** » Thu, Mar 15 2007, 7:37PM

Mike Seisser wrote:Russell,

At this time doors aren't supported in the Part Editor. Also, I'm pretty sure that you can't batch these doors either. Do you have a need to add doors/drawerfronts to a batch and be able to resize them on the fly?

Mike

Yea like he said.

Russell Walker · Post by **Russell Walker** » Thu, Mar 15 2007, 9:03PM

Hi All

No Mike, I just did them as I went along with the said kitchen, I just thought how frustrating and time consuming to go the way I was. It would be good to be able to save it all and be able to resize them as I go.

Cheers Russell

Russell Walker · Post by **Russell Walker** » Thu, Mar 15 2007, 9:06PM

Hi All

Thankyou also Michael, I haven't tried doing that operation either; I will give it a go.

Cheers Russell

Thermwood / eCabinet Systems

Add doors to Library

Add doors to Library

Re:

Editing doors

saving doors