Partially opened doors & drawers

Jack Duren · Post by **Jack Duren** » Sun, Mar 18 2007, 10:42PM

I know this has been mentioned and discussed as I have seen it while searching for other answers on eCabinets But cannot locate any info. How would I search the archieves for this?

THx....Jack

Rick Palechuk · Post by **Rick Palechuk** » Mon, Mar 19 2007, 12:29AM

Hey Jack, I believe you would build a cab with door then select door, right click, select visibility, click hide selected then go to your place items menu, select the doors/drawers radio button, develop the door you want, click OK, then rotate and move it into the position you want. HTH

DanEpps · Post by **DanEpps** » Mon, Mar 19 2007, 6:01AM

build a cab with door then select door, right click, select visibility, click hide selected

Doing this will result in two copies of the same door. You need to build the cabinet WITHOUT the door then add it manually as Rick says.

Rick Palechuk · Post by **Rick Palechuk** » Mon, Mar 19 2007, 7:33AM

That is correct Dan, you would end up with an extra door. I say to build with door to acquire the door size then REMOVE door as not to have extra. Thanks Dan.

Jack Duren · Post by **Jack Duren** » Mon, Mar 19 2007, 9:38PM

Thx for the replies and info. I'll have to give it a try.....Jack