I gave up

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 14 2007, 9:15AM

I'm pretty new to this and I started out with V5. It was pretty slow, then I added 2 GB to my computer and it wasn't as slow. Then I did the V5.1.2 upgrade, and the V5 looked speedy. I like the new options in V5.1.2 but not at the cost of that much time. Just making a new seed cabinet, once you insert a drawer it turns into a snail. I've actually screamed at the computer I can make a dovetail drawer as fast as you can compute one. I'm not kidding, I can. Well, just the dovetail routing. That is why I reverted back to V5. Small jobs on V5.1.2 aren't bad, but you just get that one cabinet too many in V5.1.2 and it slows way down.

Rick Palechuk · Post by **Rick Palechuk** » Sat, Apr 14 2007, 9:31AM

I think before new features are added to the software we need to focus on getting what we got moving smoothly.

Peter Walsh · Post by **Peter Walsh** » Sat, Apr 14 2007, 11:50AM

Guys,
I want to remind you all that in the latest release, deleting an 'assembly' in the Room Detail Mode is a known problem with a fix staged for the next release.

The workaround is:
In the Detail Room Mode
Select the assembly
Right click and choose \"Edit Assembly\"
In the Editor, delete each component separately
Click on \"Return to Room\"
Choose \"Yes\" to \"Do you want to save the changes to the room.\"

regards,

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 14 2007, 11:54AM

Peter Walsh wrote:Guys,
I want to remind you all that in the latest release, deleting an 'assembly' in the Room Detail Mode is a known problem with a fix staged for the next release.

I'll try that. Thanks Peter

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 14 2007, 1:33PM

The edit assy trick worked but I didn't do incremental saves on my work

and lost 2 1/2 hours of work to an \"OUT OF MEMORY\" error. I guess this hasn't been resolved yet.

Thermwood / eCabinet Systems

I gave up

Re: