Another time saver

Nick M Singer · Post by **Nick M Singer** » Tue, Apr 24 2007, 8:08AM

Whilst we are on the subject..... It would be nifty if you caould adjust the size of display panels. At the moment you have to delete them and recreate them

Michael Yeargain · Post by **Michael Yeargain** » Tue, Apr 24 2007, 1:19PM

While work arounds are not the perfect solution to the problem...

here's a solution to this one.

I have made a few cabinets from only the left side, or the top/bottom or the back. And used this as my dispay panels. Thus resizable. And you can apply constraints to the profiles needed.

Hope this helps some till the solution

Brent Brown · Post by **Brent Brown** » Sat, Apr 28 2007, 8:30AM

Good tip Michael,
I have used that method before, but forgot about it. I use a lot of panels to account for misc. parts used in building entertainment centers, fillers, supports for crown molding, ...

Brent

Michael Yeargain · Post by **Michael Yeargain** » Sat, Apr 28 2007, 8:39AM

You know Brent,

This software is the best. And it is so darn versatile. Dan said it best \"You know my mantra by now...\"use common parts in uncommon ways.\"

The great thing about e_cabinets is; there are no limits to its ability because of the input from so many different types of people, and their knowledge base.

This forum is a fantsitic place to live...

Thermwood / eCabinet Systems

Another time saver

Another time saver