Profile Modeler

[Ian Smith]

Hi All

I have created a TWD file on shape manager then taken to profile modeler and run a sample - works fine but when trying to fine tune it I cannot figure out how to create more than one region the profile is 750mm wide but only the outer 30mm needs work - can anyone point me in the right direction

[Daniel Vonderheide]

Ian,

When you put a profile on a panel in Ecabinets it creates one region for that profile. If you are using just one tool in Ecabinets to create a specific profile, you will only have 1 region. If you use 2 tools in Ecabinets to make a specific profile, you will have 2 regions. There is no way to break a region created with a single tool into smaller regions for machining purposes. I hope this helps.

[Ian Smith]

Going to try
Thanks

[Nick M Singer]

Ian I think you need a beer

[Ian Smith]

Hi Nick I thought if I tried 6 beers it would work even better - but I can't remember the result

Seriously Daniel - Thanks it worked a treat

[Nick M Singer]

Ian I am sure you had more than 6 when the Bokke won the World Cup last night!!!

[DanEpps]

Ian I am sure you had more than 6 when the Bokke won the World Cup last night!!!

Can you believe that South Africa beat England??? Oh wait, I guess you CAN believe it.

[Nick M Singer]

I am not a rugby watching fan myself but the whole country is in a state of disbelief Dan

[DanEpps]

Neither am I but I saw the results and couldn't believe it...15-6 South Africa over England.

Wasn't it the English that invented rugby in the first place? I guess that's the reason that American football doesn't have a \"world cup\" and baseball's world series isn't really the entire world, just North America...we just don't want to be embarassed at our own games.