Drawer box help!

[Brian Bauer]

hello,just burning up another sunday catching up on work. I Just added drawers to the cabs and tried to nest them.thats where the fun begins.can anyone take a look at the job file and see if the settings are correct,I suspect they are just as goofy as I am

Thanks Brian

[Georgi Baltov]

Hi Brian,

what exacly seems to be the problem. I can see them nest and there's an error message "Body type unknown for outline edge". They do nest though. So if you ask me I would take them to the machine and see what happens there. I would be careful and keep my hand on the emergency stop.

[Brian Bauer]

Funny Georgi, If I had a machine ( maybe towards the end of this year if sales hold steady)i would have gotten the e cab training while I was there too:)
Not too sure what the error messages are,probably something to do with the dovetail cuts on the ends. the sizes are right.

Just a thought though It would be nice to have all of the doors , drawers,and face frame stocks broke out separately, instead of all lumped into board stock or sheet stock as far as getting cutlists.

Thanks Brian