Drawer box nesting/printing problem

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Lamar Horton
Senior Member
Posts: 222
Joined: Sun, Dec 11 2005, 1:22PM
Location: Kennedale, Texas
Contact:
Contact Lamar Horton

Drawer box nesting/printing problem

Post by Lamar Horton »

I have an entire kitchen originally designed with butt joint drawers. The customer wanted dovetails. No problem, says I. In Room Detail I selected all the cabinets and changes all the drawer boxes from my butt joint box to my Dovetail joint box.

Now when I go to print the nesting sheets it tries to print two extra sheets of my birch plywood for every sheet that is shown on the screen. I need 12 sheets of birch plywood for my boxes and when I print it tries to print 36 sheets.

Help! :wall:

I even did a "save as" with a new name deleted all but one set of cabinets. Took one of the cabinets into the cabinet editor, deleted the drawers and boxes and then added them back. Returned to the room and tried to nest. The same thing is happening.
Top
Lamar Horton
Senior Member
Posts: 222
Joined: Sun, Dec 11 2005, 1:22PM
Location: Kennedale, Texas
Contact:
Contact Lamar Horton

Re: Drawer box nesting/printing problem

Post by Lamar Horton »

Oh yea to make things worse, the sheets that contain the drawer parts show up about an inch square on the page. :wall:
Top
Justin Melhiser

Re: Drawer box nesting/printing problem

Post by Justin Melhiser »

Lamar
Would you like to send me this job file? I will test it here and see if I get the same results.
Top
Post Reply

Return to “eCabinet Systems Software”