Problems Printing Nest Diagrams

Paul Caughey · Post by **Paul Caughey** » Mon, Jul 21 2008, 3:26PM

Oh please help me,

When I go to print the Nest Diagrams, part of the diagram is off the top of the page and the print below seems to be printing twice, right on top of each other in two seperat fonts. What the heck is going on here?

Paul

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jul 22 2008, 7:42AM

Paul
I ran a test cut here and it seemed to work fine. Would you send me your job that you are trying to print? I think I know what is happening but want to make sure. You can email it to me at the email listed below.

Terry Hall · Post by **Terry Hall** » Tue, Jul 22 2008, 8:54AM

Justin, please post your findings. I've had the same thing happen after build 2. Thanks

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jul 22 2008, 10:13AM

Paul and Terry
Do you have the print setup on sheet or job?

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jul 22 2008, 10:26AM

Paul and Terry

Work is planned in the future for this area. For now you will need to get the best view you can on the screen for the problem area and either print or do a screen shot.

Terry Hall · Post by **Terry Hall** » Tue, Jul 22 2008, 12:18PM

Mine is on sheet Justin.

Joe Dusel · Post by **Joe Dusel** » Wed, Jul 23 2008, 10:57PM

I had probably the same thing happen to me today. I selected the print button which brought up the print dialog box. I then selected OK, and it didn't appear that anything was happening, so I hit OK again. This cause the dialog box to be replaced by a white box. When the sheets printed all of the text and images were doubled up, and the text was printed in red.

The job is an assembly with about 10 combined cabinets.

Joe

JJWooden · Post by **JJWooden** » Sat, Jul 26 2008, 5:25PM

I'm having a similar problem. Everything seems to work fine but nothing prints. I get all of the dialog boxes and the printer select box comes up and asks if I want to print entire or select pages, either way when I click print, nothing. The hard drive light flickers like something is happening but I've waited 45 mins and nothing. I have a Vista Ultimate OS. I've tried both the job and sheet selections. I can even get the print preview to show on the screen. I've reinstalled the printer and even got new drivers for it. I tried two different printers with the same results. I'm really in a mess.

JJWooden · Post by **JJWooden** » Sat, Jul 26 2008, 6:16PM

This is a followup to my previous post about my printing problem. This is most definitely a Vista problem but I have a work around. I can still use the program on my Vista desk top computer but when I need to print I just save the job on to my lap top computer via the network. Once I open the job on the lap top (XP) I can print from there. Hope this helps someone else.

Jerry

Thermwood / eCabinet Systems

Problems Printing Nest Diagrams

Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams

Re: Problems Printing Nest Diagrams