I made an assembly and took it to Batch. When I look at the board stock listing in the cutlist it shows 8 cabinets when there are only 3. I am attaching the assembly to see if anyone has anything different.
Thanks
Greg
cutlist board stock problems
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Gregory Hairston
- Junior Member
- Posts: 69
- Joined: Sat, Nov 18 2006, 5:07PM
- Location: Memphis Tn
cutlist board stock problems
- Attachments
-
- Butlers Pantry center.esa
- (626.02 KiB) Downloaded 473 times
Successful people do the things others won't
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: cutlist board stock problems
I only get three. What are the names and quantities of all the cabinets you get on the list?
-
Gregory Hairston
- Junior Member
- Posts: 69
- Joined: Sat, Nov 18 2006, 5:07PM
- Location: Memphis Tn
Re: cutlist board stock problems
Rick,
Thanks I am only getting 3 now also. I must have had something weird going on last night. All is well now.
Greg
Thanks I am only getting 3 now also. I must have had something weird going on last night. All is well now.
Greg
Successful people do the things others won't
-
Justin Melhiser
Re: cutlist board stock problems
Gregory
If you have anything in the room layout as well as the batch when you did a cutlist, it would have shown all parts in the room and in the batch.
If you have anything in the room layout as well as the batch when you did a cutlist, it would have shown all parts in the room and in the batch.
