Edgebanding in Presentation

Iain Hall · Post by **Iain Hall** » Thu, Dec 11 2008, 4:42PM

When I hide a wall and all associated with it I am left with some edgebanding it also seems to like to leave lights that I checked are assoc. with the wall.

here is a picture any ideerrr's

DanEpps · Post by **DanEpps** » Thu, Dec 11 2008, 5:29PM

Make sure you "hide wall and associations."

Iain Hall · Post by **Iain Hall** » Thu, Dec 11 2008, 5:43PM

that picture was done after selecting hide wall and assoc.

DanEpps · Post by **DanEpps** » Thu, Dec 11 2008, 5:59PM

I know that has happened to some folks before. Have you tried searching the forum for "edge banding"?

Iain Hall · Post by **Iain Hall** » Thu, Dec 11 2008, 6:05PM

Yes but I think I got most of the forum edgebanding is a very popular topic. Searched " presentation " in side of topic but nothing relating to this.

Michael RA Greschuk · Post by **Michael RA Greschuk** » Thu, Dec 11 2008, 6:08PM

I posted this problem on June 20th. now I just add edgebanding after presentation before machining
Mike

Iain Hall · Post by **Iain Hall** » Thu, Dec 11 2008, 6:13PM

Mike different topic but do yo have a CNC

Thermwood / eCabinet Systems

Edgebanding in Presentation

Edgebanding in Presentation

Re: Edgebanding in Presentation

Re: Edgebanding in Presentation

Re: Edgebanding in Presentation

Re: Edgebanding in Presentation

Re: Edgebanding in Presentation

Re: Edgebanding in Presentation