CN 5.46 problem

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Mon, Jan 19 2009, 2:37PM

The problem occures when the part is constructed out of lines and arcks. The router cuts into the part. Also, the pockets are cleaned up before they are routed out.

Justin Melhiser · Post by **Justin Melhiser** » Mon, Jan 19 2009, 2:44PM

Nemaja
Please send in your files so we can take a look at them. Send your export file as well.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Mon, Jan 19 2009, 3:00PM

Here are all the files. I included the original .dxf, .cnc, and the export file from the NC.
Thank you Justin for quick reply.

Larry Epplin · Post by **Larry Epplin** » Mon, Jan 19 2009, 4:11PM

Hi Nemanja. The problem with the cutter cutting into the part is due to the fact that all points provided by the DXF are inside corners. This is why you are getting the warning stating an appropriate start point was not found. To resolve this you simply need to break one of your lines to provide a good start point. I have attached your DXF with this modification.

The clean up does appear to be cutting on 1 of your pockets before completion. I believe it is due to the pocket area causing more than 1 operation to perform the routing. We will get this resolved.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, Jan 20 2009, 9:47AM

Thank you Larry for all your help.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, Jan 20 2009, 2:53PM

I was cutting counter tops with dog bones for fasteners. It's a 7/16" pocket and router firt cleaned up the povcked and than routed it. Similar to the pocket in the earlier part that is in the attachment.

Thermwood / eCabinet Systems

CN 5.46 problem

CN 5.46 problem

Re: CN 5.46 problem

Re: CN 5.46 problem

Re: CN 5.46 problem

Re: CN 5.46 problem

Re: CN 5.46 problem