Exterior window image

[Joe Murphy]

Hello,
I am trying to add an image to a wall that will show up through a window cutout.
It is a photo that I have used before and is in Program Files>Thermwood>Ecabinets>Materials. However when I apply it the wall gets an image not found pattern all over it.
Any suggestions?

Thanks,
Joe

[Joe Dusel]

You might want to list the steps you are using to do this. I just tried changing the texture of a wall to a few images and it's working fine.

Joe

[Joe Murphy]

Tried It with different photos and textures and it works fine.
Don't know what was wrong with the original photo.

Thanks,
Joe

[Peter Walsh]

Joe, I believe some photos and images will not load properly unless the pixel dimension sizes can be divisible by four (if I recall correctly). Try re-sizing.
regards,