Something strange about "Change Sheet Stock"

Lamar Horton · Post by **Lamar Horton** » Sat, Feb 21 2009, 4:41PM

When changing some sheet stock in a kitchen I am working on I see drawer parts mixed with the pieces of that cabinet. There are no drawer in any of the upper cabinets. When I nest the job, it nests correctly. But when I open the sheet stock changer I see the drawer parts. This is not a problem just something that seems out of place.

Walker T Scott · Post by **Walker T Scott** » Mon, Feb 23 2009, 7:53AM

Could you attach the job and will take a look at.
Thanks

Lamar Horton · Post by **Lamar Horton** » Mon, Feb 23 2009, 9:10PM

Here it is

Walker T Scott · Post by **Walker T Scott** » Tue, Feb 24 2009, 8:26AM

Lamar

This is caused by the drawer box you have in your base cabinets. I’ve tried changing the drawer box material and even changing the drawer box but none of that fixes the problem. I have listed this for the programmers.
Thanks

Thermwood / eCabinet Systems

Something strange about "Change Sheet Stock"

Something strange about "Change Sheet Stock"

Re: Something strange about "Change Sheet Stock"

Re: Something strange about "Change Sheet Stock"

Re: Something strange about "Change Sheet Stock"