won't nest whole job

Lorin Ylioja · Post by **Lorin Ylioja** » Tue, May 26 2009, 8:01PM

Hi
I have desig ed a complete kitchen in the custom layout but when I try nest it only some of the cabinets nest. I get no error message or parts won't nest. It acts as if it only sees about half of the job. When I try saved jobs it works.
thank you
Lorin

Lorin Ylioja · Post by **Lorin Ylioja** » Tue, May 26 2009, 8:46PM

In case it makes a difference the cut list is complete and individual cabinets nest.
thanks again
Lorin

Iain Hall · Post by **Iain Hall** » Tue, May 26 2009, 10:34PM

Did you check the filtering to see if for some reason some of the cabinets are turned of in there

Lorin Ylioja · Post by **Lorin Ylioja** » Tue, May 26 2009, 10:41PM

I checked this now and all the cabinets are checked. I think it is actually nesting 6 or 7 of the 20.
Thanks for this advice. I had never used the filter before.
Lorin

Iain Hall · Post by **Iain Hall** » Wed, May 27 2009, 1:21AM

That uses up all I know there are others here that can make E cab dance if they want to. I know just enough to be dangerous.

Kerry Fullington · Post by **Kerry Fullington** » Wed, May 27 2009, 6:32AM

Ian,

Did you try re-starting your comoputer and then nest the job?

Post your job so we can try to nest it.

Kerry

Lorin Ylioja · Post by **Lorin Ylioja** » Thu, May 28 2009, 12:13AM

Thanks for the help. Your email got me straightened out Kerry.

Leo Graywacz · Post by **Leo Graywacz** » Fri, May 29 2009, 7:56PM

OK Kerry, spill it. What was in the email that made things all better.

Lorin Ylioja · Post by **Lorin Ylioja** » Fri, May 29 2009, 11:31PM

I had to delete the toe kick on one cabinet. I am not sure why, but it worked after this.
Lorin

Thermwood / eCabinet Systems

won't nest whole job

won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job

Re: won't nest whole job